LL nozzles are small plastic parts designed for mixing two-component Plastiform in cartridges. This category of nozzles can be equipped with needle tips at the end.
LL nozzles fit all 50ml cartridges and are slightly smaller than standard nozzles, allowing them to fit into tighter shapes. You can use this nozzle WITH or WITHOUT a needle at the end, but we highly recommend using it only when you need a needle for your application.
Start the injection only when you are fully prepared to perform your controls. Do not use pasty products with this nozzle when a needle is attached at the end.
Once the product is mixed inside, it begins to cure and will polymerize within a few minutes. After polymerization, the nozzle is no longer reusable and must be discarded.
Unlike the tips, the needle cannot be reused after the polymerization process, as it is impossible to remove the cured product inside.
Nozzles are essential accessories for applying Plastiform in 50ml cartridges. LL nozzles are not included with the cartridges and must be ordered separately.
The LL nozzle is attached to the end of the cartridge after you remove the cap. Simply push the nozzle onto the cartridge and turn it to the right to lock it in place.
If you need to use a needle, clip it onto the nozzle’s outlet. The nozzle and needles are specially designed to fit together.
Once the LL nozzle is mounted on the cartridge, you can attach the assembly to the dispensing gun and begin your application.
Before applying a Plastiform product, you must clean the application surface with DN1 degreaser.
Looking for a complete kit to try plastiform?
The case contains all required accessories to use Plastiform. It is the best way to try our solutions for the first time!
Are Plastiform products compatible with all types of metal alloys?
We always recommend carrying out a preliminary test to confirm that your alloy will not adhere to the product, as we have observed several cases of incompatibility with very specific alloys, although this is very rare.
What’s a good application for Fill’Ins ?
Fill'in s are a good match when you need to create a total impression of an internal shape with a diameter of less than 5mm. As a general rule, if you are using a Needle Injector, you might have a Fill'In application.
What is the smallest diameter at which these products can be effectively used?
For very small diameters (< 5mm), it's best to use a liquid product and make a full impression. However, there is no minimum diameter. Use needle nozzles if you need more precision when pouring the product.
What are nozzles and tips used for?
The nozzle should be attached at the end of the cartridge, ensures that the two components of the plastiform mix homogeneously before application. It is a consumable item and must be replaced after each use. The tip, which is fitted at the end of the nozzle, reduces the flow rate. This is particularly recommended for fluid plastiforms to achieve optimal application accuracy, especially in fine details. The tip is reusable and can be cut to increase the flow if needed.
Which application gun should we choose?
The choice of the application material depends on the cartridge size. For 50mL cartridges, there are two options: the manual DM-50 gun or the pneumatic DP-50 gun. The main difference lies in ease of use; the DP-50 is less cumbersome for users who take repeated impressions. For 400mL cartridges, the options are the manual DS-400 or the pneumatic DP-400 guns. Additionally, there is the DB-400, a battery-operated gun.
Related Products
Considered the LL Nozzles for your application but it doesn’t exactly answers to your requirements? You may also find these alternative products helpful.
AC-030
